Affordable engineering lamp strips are used in a wide range of applications. High temperature resistant flexible engineering lamps are cost-effective, low-cost and environmentally friendly. Whether it is home improvement or outdoor decoration, the engineering light belt is the best choice. The blue, yellow, white and pink four new styles of light have made the home shine.

Engineering lamp belt market first, national priority, high temperature resistant flexible LED back base film, high temperature resistant modification, high temperature resistant hot melt adhesive, release film, cost-effective process, low consumption, green environmental protection, excellent yellowing resistance, deformation resistance Good appearance, good electrical properties, excellent resistance to 5000v breakdown and hot pressing process, suitable for on-line monitoring, high temperature and normal temperature storage, high precision, high productivity, high stability, high quality, high cost performance, based on innovative backplane Membrane and engineering light belts are the only ones. In the Chinese light strip market, the second season engineering light strips have not been found so far, with high cost performance, good quality, long shelf life and high selectivity. The first choice for professional outdoor rainproof sunscreen.

1. Indoor installation: When the engineering light is used for interior decoration, the installation is very simple because it does not have to withstand wind and rain. Take the engineering light strip produced by Guanghong Electronics as an example. Each engineering light strip is covered with self-adhesive 3M double-sided adhesive tape. When installing, you can directly tear off the sticker on the surface of 3M double-sided adhesive tape, and then fix the light strip in need. Place it by hand and press it flat with your hand. As for some places that need a corner or a long length, it is very simple. The engineering light strip is a circuit structure consisting of three LEDs in a series-parallel manner. Each of the three LEDs can be cut and used separately.

2, outdoor installation: outdoor installation will be subject to wind and rain, if the use of 3M glue fixed, the time will cause 3M adhesive viscosity to reduce the engineering light strip off, so the outdoor installation often uses the card slot fixed way. The place that needs to be cut and connected is the same as the indoor installation, except that it needs to be additionally equipped with waterproof glue to consolidate the waterproof effect of the joint.

3. Power connection method: The general voltage of the engineering lamp is 12V DC, so it needs to be powered by the switching power supply. The size of the power supply is determined according to the power of the engineering lamp and the connection length. If you don't want each engineering light strip to be controlled by a power supply, you can purchase a relatively large power supply for the total power supply, and then connect all the engineering lights with the input power supply in parallel (if the wire size is not enough, you can extend it separately). Uniformly powered by the main switching power supply. This kind of advantage is that it can be controlled centrally. It is inconvenient that the lighting effect and switch control of a single engineering light strip cannot be realized. The specific method can be measured by itself.